Printronix P9212 Setup Manual page 183

Table D–1. Factory Default Configuration Values (Continued)
Configuration
Parameter
Host Interface
Dataproducts
Data Bit 8
PI Line
Data Polarity
Resp. Polarity
Strobe Polarity
Latch Data On
Notes:
1. This parameter is displayed only if P-Series XQ printer protocol is selected.
2. This parameter is displayed only if Serial Matrix printer protocol is selected.
3. This parameter is displayed only if P-Series printer protocol is selected.
4. This parameter is displayed only if P-Series or P-Series XQ printer protocol is selected.
5. For P-Series printer protocol, the factory default parameter value is "EVFU". For P-Series XQ
protocol, the value is "Enable". For Serial Matrix protocol, the parameter is not displayed.
6. The paper out adjust value is not affected by loading, saving, or clearing NVRAM. Its value may
only be explicitly changed in the menu.
7. If P-Series XQ or Serial Matrix printer protocol is selected, the factory default parameter value is
"Not Applicable".
Predefined Configuration Values
Factory Default
Value
Enable
7
Enable
Standard
Standard
Standard
Leading Edge
Configuration
Parameter
Host Interface
Serial RS-232
Data Protocol
Data Rate
Word Length
Stop Bit
Parity
Bit 8 Function
Data Term Ready
Request To Send
Reverse Channel
Factory Default
Value
X-ON/X-OFF
9600 BAUD
8 Bits
One
None
Font Select
On-Line and BNF
On-Line and BNF
On-Line and BNF
D–3