Web Configuration Panel; Making And Receiving Calls - Yeastar Technology TA400 User Manual

Web Configuration Panel

There are 4 main sections on the Web Configuration Panel for users to check the
TA400/800's status and configure it.

Status: check System Status, Port Status, Trunk Status, Network Status and
check call logs, system logs.

System: configure Network Settings, Security related Settings, System Date and
Time, Password, Backup and Restore, etc.

Gateway: configure FXS ports, gateway settings and SIP settings, etc.

Logout: log out TA400/800.
Note:
After saving the changes, remember to click the ―Apply changes‖ button on the upper
right corner of the Web GUI to make the changes take effect.

Making and Receiving Calls

You will need an active VoIP account from a VoIP service provider or PBX, which
provides a VoIP telephone number to allow you to make and receive calls.

Making internal calls
To place an internal call, pick up the analog phone and dial the other port's caller
ID number or dial *99 followed by the port number.
For example, to reach the other port with caller ID number 300, dial ―300‖.
To reach port 2, you can dial *9902 to ring the phone connected to port 2.

Making outbound calls
To make an outbound call, you need to dial according to the FXS port dial pattern.
By the default dial pattern, you can dial the desired outgoing number directly.

Answering calls
To answer a call, pick up the handset as you usually do.
TA400/800 User Manual
7/64