Dial Pattern Template - Yeastar Technology TA400 User Manual


 Advanced
Table 5-2 Description of VoIP Server Advanced Settings
Items
Enable SRTP
Qualify
Caller ID
Maxmum Channels
Realm
Authenticating
Incoming Call
DTMF Mode
Codec

Dial Pattern Template

Dial pattern template specifying how to route the calls from FXS ports to VoIP server
extensions or external numbers. The number of dial pattern templates is limited by the
number of ports each TA FXS Gateway model has.
same account.
Service Provider: disable registration.
Description
Define if SRTP is enabled for this VoIP server.
Send check alive packets to the SIP provider.
Specify the caller ID to use when making outbound calls over
this VoIP server.
Control the maximum number of simultaneous calls. Set as 0
to specify no maximum.
Realm is a string to be displayed to users so they know which
username and password to use.
When an incoming call reaches TA device and sends INVITE
packet to TA, TA responds 401, but the Realm info in 401
Response does not match the Realm set on TA VoIP Server,
the provider will refuse to authenticate. If you set this option to
No, TA will not reply a 401 Response to the provider to
authenticate the incoming call.
Set default mode for sending DTMF of this trunk. Default
setting: rfc2833
Define the codec for this sip trunk and its priority. TA400/800
supports the following codec: u-law, a-law, G726, G729A/B,
GSM, ADPCM, G722, G723, iLBC.
Figure 5-3 Dial Pattern Template
TA400/800 User Manual
20/64