Web Configuration Panel; Application Description - Yeastar Technology TA3210 User Manual

Web Configuration Panel

There are 4 main sections on the Web Configuration Panel for users to check the
TA3210's status and configure it.
Status: check System Status, Port Status, Trunk Status, Network Status, call

logs, and system logs, etc.
System: configure Network Settings, Security related Settings, System Date and

Time, Password, Backup and Restore, etc.
Gateway: configure FXO ports, gateway settings and SIP settings, etc.

Logout: log out TA3210.

Note: After saving the changes, remember to click the "Apply changes" button on the
upper right corner of the Web GUI to make the changes take effect.

Application Description

Connect IPPBX and TA FXO Gateway
Yeastar TA FXO gateway is a solution to extend FXO ports for your IPPBX.
Two modes are available for you to connect IPPBX and TA FXO gateway, we call
them VoIP mode and SPS (Service Provider SIP)/SPX (Service Provider IAX) mode.
Three modes are available for you to connect your SIP server and TA3210 gateway.
We call them SIP Account Mode, VoIP Mode and SPS (Service Provider SIP) Mode.
You can choose any one of the 3 modes to connect your SIP server and TA3210. SPS
Mode is recommended.
Account Mode:
Create one SIP account on TA3210, and take the SIP account to register one SIP
trunk on your SIP server. Then TA3210 and your SIP server are connected by the
account.
Calls from SIP to PSTN

1) Create one outbound route on your SIP sever, and select the SIP trunk you
have registered just now.
2) Configure a "IP->Port" route on TA3210, choose the SIP account in the field
"Call Source", and choose a PSTN trunk or PSTN trunk group in the field "Call
Destination".
3) Make a call from your SIP Server and the call should match the outbound
route dial rules.
TA3210 User Manual
7/66