Iax Settings - Yeastar Technology TA400 User Manual

DID Field
180 Ringing
Remote Party ID
Allow Guest
Pedantic
Alwaysauthreject
OPTIONS Response 200
Session-timers
Session-expires
Session-minse
Session-refresher

IAX Settings

IAX is the Internal Asterisk Exchange protocol, you can connect to TA FXS Gateway
or register IAX trunk to another IAX server. It's supported by the asterisk-based
IPPBX.
Items
UDP Port
Bandwidth
Where to get the DID in SIP packet.
It is set when the telecom provider needs. Usually
it is not needed.
Whether to send Remote-Party-ID on SIP header
or not. Default: no.
Whether to allow anonymous registration
extension or not. Default: no. It's recommended
that it is disabled for security reason.
Enable pedantic parameter. Default: no.
If enabled, when TA FXS Gateway rejects
―Register‖ or ―Invite‖ packets, TA FXS Gateway
always respond the packets using ―SIP404 NOT
FOUND‖. It's recommended that it is enabled for
security reason.
If set to yes, the response to an OPTIONS is
always 200OK.
Enable session-timer mode, default: yes. If you find
the call is cut off every 15 minutes every time,
please disable this.
The max refresh interval
The min refresh interval, which mustn't be shorter
than 90s.
Choose the session-refresher, the default is Uas.
Figure 5-10 IAX Settings
Table 5-8 Description of IAX Settings
Description
Port used for IAX2 registrations. Default is 4569.
Low/medium/high with this option you can control which
TA400/800 User Manual
26/64