Voip Settings; Voip Server Settings - Yeastar Technology TA400 User Manual

VoIP Settings

To integrate with other IPPBX, we need to configure the VoIP settings in TA FXS
Gateway to set up VoIP trunk (SIP and IAX). In this chapter, we introduce the following
settings:


VoIP Server Settings


Dial Pattern Template

SIP Settings

IAX Settings
VoIP Server Settings
There are some configurable VoIP (SIP/IAX) Server templates on this page. The
number of VoIP Server templates is the half of FXS ports on TA FXS Gateway. The
VoIP server settings help the FXS ports to register to the VoIP server. Once
configured, the templates can be chosen on FXS port setting page.
There are 3 register modes for VoIP server. Users could select one mode for the VoIP
server and apply it to FXS ports.

Service Provider - IP Based VoIP Provider, do not generally require the TA
gateway to register with the provider. Only IP address or domain is needed to
configure on TA gateway.
Note: this is a peer-to-peer mode to connect VoIP server and TA gateway, you
also need to create a service provider trunk connecting to TA gateway on your
VoIP server.

Port Register – the VoIP server requires TA gateway to register with the provider
using an authentication ID and password.
If you choose the VoIP server, you need to fill in User Name, Authentication Name
and Password to register the FXS port.

Template Register – register to your VoIP server and apply the template to FXS
ports. The FXS ports will register to the server with the same account.
Figure 5-1 Port Register
TA400/800 User Manual
18/64