Chapter 1 Introduction; Overview; Software Requirements - Oki OKILAN 6100E+ User Manual

Chapter 1
Introduction

Overview

This section contains instructions and information on
how to configure your OkiLAN 6100e+. You will also be
instructed on how to set up your host computers to print
to the OkiLAN 6100e+ using the TCP/IP protocol.
OkiLAN 6100e+ supports three TCP/IP methods for
printing:
• Remote Line Printer Daemon (LPD)
• File Transfer Protocol (FTP)
• Printing directly through a TCP port (Raw Port
Printing)

Software Requirements

The OkiLAN 6100e+ may be configured for TCP/IP
using the OkiNet for TCP/IP utility, or from a computer
supporting the OkiNet for NetWare utility, Banyan
VINES OkiNet for VINES utility, OR telnet and one of
the following:
• Manual arp table entry and ping
• Static route entry using route add command
• DHCP
• RARP
• BOOTP
OKI OkiLAN 6100e+ User's Guide
Section 4 - Chapter 1 - Introduction
IV - 5