Installing The Utilities Software - Oki OKILAN 6100E+ User Manual

Section 6 - Chapter 2 - Installation
• The initial installation requires the file server to be
brought down and then back up again. This may be a
consideration when you are planning your install.
Depending on your current configuration, the following
software may also be needed:
• Printer driver installation diskettes. These diskettes
are provided with the OS/2 operating system or are
available from the printer manufacturer.
• LAN Manager or LAN Server installation diskettes.
Note: It is strongly recommended that you make
backup copies of the OS2.INI and
OS2SYS.INI files before you install the
OkiLAN 6100e+. Follow the directions in your
OS/2 documentation to back up these files.

Installing the Utilities Software

Two software utilities are provided with the OkiLAN
6100e+: INSTALL and OkiNet for OS/2.
Install
The INSTALL utility copies both software utilities to
your OS/2 server and registers the OKI application with
the OS2.INI file. You will need to run INSTALL one
time only.
OkiNet for OS/2
The OkiNet for OS/2 utility completes the initial
installation of the OkiLAN 6100e+. In addition, you
can run the utility as needed to modify the
configuration of the OkiLAN 6100e+ or to view port
information.
Note: The directory where OKI DLL files install,
c:\OS2\DLL, must be the first entry in the
LIBPATH command located in the
CONFIG.SYS file. When you reboot the
system, the OS/2 spooler will load the OKI
Network Printer Redirector.
VI - 6 OKI OkiLAN 6100e+ User's Guide