Oki OKILAN 6100E+ User Manual page 122

Section 4 - Chapter 5 - Telnet Configuration
RARP or BOOTP server does not need to be available
when the OkiLAN 6100e+ is powered on.
If you change the IP address, the change will remain
undetected until the OkiLAN 6100e+ is reset or is
powered off and on.
Remember, when choosing a permanent IP address:
• The IP address must follow the format
XXX.XXX.XXX.XXX, where each XXX is a
number between 0 and 255.
• If you select an invalid IP address you may not be
able to access the OkiLAN 6100e+.
• You can also use OkiNet for TCP/IP, OkiNet for
NetWare or the Banyan VINES OkiNet for VINES
utilities to set a permanent IP address.
Note: If you select an invalid IP address you may not
be able to access the OkiLAN 6100e+. Use this
option with care!
Specify the Subnet Mask for Your Network
(Option 4)
If your network environment includes subnets, you will
want to set the subnet mask.
The subnet mask must follow the format
XXX.XXX.XXX.XXX, where each XXX is a number
between 0 and 255.
The default subnet mask is 0.0.0.0. The OkiLAN 6100e+
interprets a subnet mask of 0.0.0.0 or 255.255.255.255
as no subnet mask specified.
If you change the subnet mask, the change will remain
undetected until the OkiLAN 6100e+ is reset or is power
cycled.
Note: If you select an invalid subnet mask you may
not be able to access the OkiLAN 6100e+. Use
this option with care!
IV - 44 OKI OkiLAN 6100e+ User's Guide