Chapter 1: Introduction; Chapter 1Introduction; In This Section; Overview - Oki OkiLAN 6120e User Manual

Chapter 1
Introduction

Overview

This section contains instructions and information on
how to configure your OkiLAN 6120e. You will also be
instructed on how to set up your host computers to print
to the OkiLAN 6120e using the TCP/IP protocol.
OkiLAN 6120e supports TCP/IP methods for printing:
• Remote Line Printer Daemon (LPD)
• File Transfer Protocol (FTP)
• Printing directly through a TCP port (Raw Port
Printing)
Additionally, if the DHCP protocol is enabled as a
default, the print server may be accessed through an
ordinary Internet Web browser, such as Netscape
Navigator, or by using TELNET. See Chapters 5 and 6

in this section.

Software Requirements

The OkiLAN 6120e may be configured for TCP/IP
using the OkiNet for TCP/IP utility, or from a computer
supporting the OkiNet for NetWare utility, Banyan
VINES OkiNet for VINES utility (may apply to other
OkiLAN print server models), OR telnet and one of the
following:
• Manual arp table entry and ping
• Static route entry using route add command
• DHCP
• RARP
• BOOTP
OKI OkiLAN 6120e User's Guide
Section 4 - Chapter 1 - Introduction
IV - 5