Oki OKILAN 6100E+ User Manual page 154

Section 4 - Appendix B - Application Considerations
6. Start the qdaemon by typing:
7. Try printing to the printer attached to the OkiLAN
6100e+ by issuing the following command:
Configuring Solaris 2.x for Printing
with the OkiLAN 6100e+
This application note describes the configuration of the
printing system on the Solaris ver. 2.x UNIX operating
system. For clarity and brevity, the following specific
names will be used to represent general devices or
concepts.
• lj4 - The local queue name on the Solaris system
to which print jobs that are destined for a printer
attached to the OkiLAN 6100e+ will be directed.
• OKIPRINTER - The host name of the remote
system which is the OkiLAN 6100e+. For example,
to telnet to the OkiLAN 6100e+ and invoke the
OkiLAN 6100e+ Configuration utility, you would
type telnet OKIPRINTER. A host name is not
required for the OkiLAN 6100e+, the IP Address
may be used.
• yourqueuename - This is the name of the queue
on the OkiLAN 6100e+ and must end with 1, 2, 3
or 4, depending on the port selected to service the
print jobs.
If FF, LF or NF are the last two letters of the
queue name, the job will be converted
accordingly. See pages IV-15 and IV-16 for more
information on remote queue names.
IV - 76 OKI OkiLAN 6100e+ User's Guide
AIX> startsrc -s qdaemon
AIX> lpr -Plj4 filename