Oki OKIOFFICE 84 User Handbook Manual page 67

4 IMAGE IN MCF: When a message confirmation is
printed, this function adds a portion of the first page your
MFP transmitted. This is printed at the bottom of the
message confirmation report. Available settings are on
and off.
5 SENDER ID: This function controls the printing of your
MFPs Sender ID on the faxes you send. When turned on,
your MFPs Sender ID will be printed on each page
slightly outside the image area of your document. When
turned off, your MFPs Sender ID will not be printed. FCC
regulations require that this setting be ON in the United
States.
6 MONITOR VOLUME: This function sets the volume
your MFP uses for telephone line monitoring sounds
during dialing. Available settings are low, high and off.
7 BUZZER VOLUME: This function sets the volume of
the various beep and alarm tones your MFP emits during
operations. Available settings are low, middle and high.
8 CLOSED NETWORK: This function allows you to
program your MFP to refuse to receive faxes from or
transmit faxes to locations whose telephone numbers
have not been programmed into your MFP's One Touch
|
60 Handbook
keys or Auto Dial numbers. Using this function, you can
set up a closed network of fax machines. If you do not
want your MFP to transmit faxes to or receive faxes from
locations outside your network, select T/R. If you only
want your MFP to refuse to receive faxes from outside
your network, select RX. Available settings are OFF, T/R
and RX.
9 TX MODE DEFAULT: This function allows you to
change your MFP's default type of original and transmit
resolution settings. Unless you select otherwise using the
Transmit Resolution/Yes
keys, your MFP is set to use the STD and NORMAL
settings. If you are constantly sending faxes, which
require some other combination of transmission modes,
use this function setting to change the default
transmission modes to any other combination of settings.
While you are programming, the new default
combinations will appear on the LEDs above the
Transmit Resolution/Yes
keys.
10 T/F TIMER PROG: When set to the telephone/ fax
answering mode, your MFP automatically distinguishes
between incoming voice and fax calls. If the incoming
call is a voice call, your MFP will ring to tell you to pick
up the handset. If you do not answer, your MFP
or Type of Original/No
or Type of Original/No