Initiating A Relay Broadcast; Rejecting Unsolicited Fax Messages - Oki OKIOFFICE 84 User Handbook Manual

Initiating a Relay Broadcast

1 Load your documents.
2 Press the Select Function key.
3 Press the 4/Relay Initiate TX One Touch key. The
display shows RELAY PASSWORD.
4 Press the No key.
5 Using the numeric keypad, enter a 4-digit password
which is the same as the relay keyword programmed into
the relay key station.
key. The display shows REMOTE LIST
6 Press the Yes
NO.
7 Press the No key.
8 Using the numeric keypad, enter a 2-digit number that
corresponds to a relay group programmed into the relay
key station.
key. The display shows SELECT
9 Press the Yes
10 Select the location of the relay key station. Refer to the
instructions below.
To Select Using
A One Touch key
An Auto Dial number
Do This
Press the One Touch key.
Press the Auto Dial key,
then enter the two digit
A group
A number dialed on
the numeric keypad
11 Press the Start key. Your MFP will begin sending the fax.

Rejecting Unsolicited Fax Messages

The closed network option allows you to limit the locations
your MFP can communicate with. Using this function, you
can set your MFP to refuse to receive any incoming faxes
from locations whose telephone numbers are not programmed
into your One Touch keys or Auto Dial numbers (RX). In this
way your MFP automatically rejects unsolicited fax messages
such as advertising. You can also set your MFP to neither
send faxes to nor receive faxes from, locations whose
telephone numbers are not programmed into your One Touch
keys or Auto Dial numbers (T/R). The available settings are:
Limit reception only (RX)
Auto Dial number on the
numeric keypad.
Using the numeric
keypad, press the # key,
then enter the number of
the group.
Dial the number as you
would on a normal
telephone, then press
start.
|
Handbook 55