Network Setup; General; Figure 27: Network - General Setup Screen - Eneo TVR-2008AM4.0 User Manual

Network Setup

General

Highlight the first box beside Remote Watch – bps/ips. You can select the Transfer Speed. The available value
differs depending on the quality and resolution settings.
Highlight the second box beside Remote Watch – bps/ips. You can select the unit of measure for the transfer speed
between: bps and ips. Press the
Highlight the box beside Remote Watch – Quality and press the
High, High, Standard and Basic. Press the
Highlight the box beside Remote Watch – Resolution and press the
Very High, High and Standard. Press the
NOTE: The higher Quality and Resolution settings require higher Transfer Speed settings. The transfer speed
you set is the maximum speed. Depending on the network environment, this speed may not be achieved.
You can limit the network bandwidth settings so that the system does not consume too much network bandwidth. Highlight
the box beside Network Bandwidth Limit and press the Up and Down arrow buttons to set the desired maximum bandwidth
from 100Kbps to 1Gbps.
NOTE: When limiting the network bandwidth, the remote watch image on the PC running RAS or WebGuard
might not be displayed properly.
The DVR supports two-way audio communication between a local system and a PC running RAS. Highlighting the box
beside Remote Audio Channel and pressing the
remote site. Selecting Select From RAS will send audio of the channel selected from RAS.
NOTE: Depending on network conditions, audio might be interrupted or out of synchronization during
transmission.
Highlight Enable SSL for Transferring Data and press the
the security of data except video and audio transmitted for remote monitoring or remote recording can be enhanced by
using the SSL (Secure Sockets Layer) authentication. When using the SSL function, the DVR cannot be connected with
a remote program or a network keyboard which does not support the SSL function.
CAUTION: The remote connection will be disconnected temporarily after changing the SSL settings.
Figure 27: Network – General setup screen.
button to set the transfer speed.
button to set the Quality.
button to set the Resolution.
button allows you to select the audio channel that sends audio to the
button. You can select the Quality from: Very
button. You can select the Resolution from:
button to toggle between On and Off. When it is On,
Digital Video Recorder
41