Ptz; Figure 23: Camera - Ptz Setup Screen - Eneo TVR-2008AM4.0 User Manual

User's Manual

PTZ

NOTE: You will only be able to set up PTZ devices if the PTZ port is set to RS232 or RS485.
You can assign IDs to each camera by highlighting the box under the ID heading and pressing the
number by highlighting it and using the Up and Down arrow buttons to increase and decrease the number. The PTZ
ID number can be set from 0 to 256.
You can assign the maximum number of presets to each camera by highlighting the box under the Maximum Preset
heading and pressing the
to increase and decrease the number. The maximum preset number can be set from 0 to 256.
NOTE: Please check out the maximum number of presets that the camera supports. If the number you
assigned exceeds the camera's and one of the exceeded presets operates, the camera may malfunction.
Highlight the Setup... box and press the
38
Figure 23: Camera – PTZ setup screen.
Highlight the box in the Product column for the PTZ camera you wish to configure
and press the button. A list of PTZ devices appears. Select your camera from
the list and press the
or RS485 connector on the back of the DVR following the camera manufacturer's
instructions.
button. Change the number by highlighting it and using the Up and Down arrow buttons
button. The Port Setup window appears.
Configure the port's setting based on the PTZ camera manufacturer's instructions.
button. You will need to connect the camera to the RS232
button. Change the