Panasonic KX-TDA50 Feature Manual page 79

• Time Service Switching Mode (→ 1.17.5 Time Service)
DISA Automatic Walking COS
Registered outside destinations such as cellular phones can be automatically recognized as PBX
extensions when calling through DISA. When the Caller ID of a received CO line call matches an entry in
the System Speed Dialing Table, the calling telephone is given Walking COS authorization as assigned to
the corresponding CLI destination extension. Therefore, the "CLI destination" setting in the System Speed
Dialing Table is used here to specify the target extension that the calling telephone will be recognized as for
Walking COS.
[Programming Example of DIL Table]
CO Line
No.
Day
01 Disable
: :
"CLI" must be set to Disable, to allow incoming calls to be received by DISA.
2.16.2 [10-2] DIL Table & Port Settings
→ DIL—DIL Destination—Day, Lunch, Break, Night
→ CLI for DIL—CLI Ring for DIL—Day, Lunch, Break, Night
[Programming Example of System Speed Dialing Table]
Location
000
001
:
2.12.1 [6-1] System Speed Dial
→ CO Line Access Number + Telephone Number
→ CLI Destination
In this example, calls received on CO line 01 are routed to the DISA OGM with floating extension number
501. If the number of the received call (after modification according to the Caller ID table) is "1-234-111-
5678", the call originator is recognized as extension 200, and the Walking COS feature is automatically
activated.
System programming is required to enable this feature.
SMDR
The call information for DISA is recorded as the one of the DISA floating extension numbers. (→ 1.16.1
SMDR (Station Message Detail Recording))
Conditions
[General]
WARNING
There is a risk that fraudulent telephone calls will be made using the CO-to-CO Line Call feature of
CLI
Lunch ...
Disable ...
: :
CO Line Access +
Name
Telephone Number
J. Smith
:
:
DIL Destination
Day Lunch
501 501
(DISA) (DISA)
: :
912341115678
:
:
1.4 D
...
...
:
CLI Destination
200
:
:
Feature Manual 79