Panasonic KX-TDA50 Feature Manual page 276

1.16 S
Number in
the Pattern
(5)
(6)
(7)
(8)
276 Feature Manual
Data
Dial Number [CO Line Call]
Outgoing CO Line Call
Shows the dialed telephone number.
Digits shown are as follows:
0 through 9, , #
P: Pause
F: External Feature Access (EFA) signal
=: Host PBX Access code (→ 1.8.5 Host PBX Access Code
(Access Code to the Telephone Company from a Host PBX))
. (dot): Secret dialing
–: Transferred call
If the transfer destination extension enters additional digits, those
digits will be added after "–".
Incoming CO Line Call
Shows <I> + the caller's identification name/number.
It is also possible to show the DID call information. In this case,
<D> + DID name/number is added before <I> .
[Outgoing Intercom Call]
Shows the dialed extension number followed by "EXT".
[Log-in/Log-out]
Shows the Log-in or Log-out status.
[Check-in/Check-out]
Shows the check-in or check-out status. (→ 1.15.3 Room Status
Control)
[Timed Reminder]
Shows the status of a timed reminder, either "Start", "No Answer",
or "Answer". (→ 1.17.4 Timed Reminder)
[Printing Message]
Shows the selected message. (→ 1.13.11 Printing Message)
[Sensor Call]
Shows calls from an external sensor as follows:
<I> S + sensor number. (→ 1.5.9 External Sensor)
Ring Shows the ring duration before the call was answered in minutes/
seconds.
Duration Shows the duration of the CO line call in hours/minutes/seconds.
Acc Code Shows the account code appended to the call. (→ 1.1.2 Account
(Account Code) Code Entry)
Description