Access Levels - Panasonic KX-TDA50 Pc Programming Manual

2.1.2 Access Levels

Setting
Port Number
2.1.2 Access Levels
There are three main levels of access to the Maintenance Console: User, Administrator and Installer. Each
level has its own Programmer Code, which must be entered to run the Maintenance Console. The allowed
format for each programmer code is as follows:
User Level Programmer Code
Administrator Level Programmer Code
Installer Level Programmer Code
Access to menu options within the Maintenance Console is restricted depending on the Programmer Code,
and the current software mode (see 2.1.1 Starting Maintenance Console and Software Modes). When a
menu option is limited to certain access levels, this is noted in this manual in the initial description of that menu
option, for example:
"This option is only available at Installer level."
If a sentence like this does not appear under the heading, the menu option is available at all levels.
The target users for each access level are as follows:
Access Level
User
Administrator
Installer
The options available in each mode and access level are shown below.
The access levels are abbreviated as follows:
U: User; A: Administrator; I: Installer
A check mark indicates that the menu option is available for that access level.
Program launcher
New
18 PC Programming Manual
Values
10000–65535
Item
Menu Option
Explanation
Specify the port number used to access
the PBX via LAN. Enter the same port
number that was input in Maintenance
Port Number of 3.30 [1-1] Slot—Card
Property - CTILINK (KX-TDA100/
KX-TDA200/KX-TDA600 only) or
3.19 [1-1] Slot—Card Property - IP
Gateway (KX-TDA50 only).
Length
0 – 16 characters
4 – 16 characters
4 – 16 characters
User
For end users
For system administrators
For dealers and system installers
Batch
U A I U
ü
Interactive
A I
ü
Document Version 2010-11