Maintenance Console Location
3.17 [1-1] Slot—Port Property - T1 Port (KX-TDA100/KX-TDA200/KX-TDA600 only)
Programming Manual References
None
Feature Manual References
3.1.21 CPC (Calling Party Control) Signal Detection
CPC Signal Detection (LCO/GCO)—Outgoing, Incoming
Specifies the length of time required by the PBX to detect a CPC signal on outgoing or incoming CO line calls
before disconnecting the line. When None is selected here, the line will not be disconnected when a CPC
signal is not detected.
This setting is only available when Channel Type on this screen is set to GCOT or LCOT.
Default
160 ms
Value Range
None, 8 ´ n (n=2–112) ms
Maintenance Console Location
3.17 [1-1] Slot—Port Property - T1 Port (KX-TDA100/KX-TDA200/KX-TDA600 only)
Programming Manual References
None
Feature Manual References
3.1.21 CPC (Calling Party Control) Signal Detection
DTMF Width
Selects the length of the DTMF tone sent to the T1 channel.
Default
80 ms
Value Range
80 ms, 160 ms
Maintenance Console Location
3.17 [1-1] Slot—Port Property - T1 Port (KX-TDA100/KX-TDA200/KX-TDA600 only)
Document Version 2010-11
3.17 [1-1] Slot—Port Property - T1 Port (KX-TDA100/KX-TDA200/KX-TDA600 only)
PC Programming Manual
177