Clearing The Transaction Log; Setting When Transaction Log Full Message Displays - Pitney Bowes DM125 Operator's Manual

Clearing the Transaction Log

You can manually clear transaction data if you are receiving
warnings that the transaction log is full, or near full.
Refer to the next two sections on Transaction Log Full settings for
more information about transaction log warnings.
Follow the steps below to clear transaction data.
1. Press the Home key to display the Home screen, then select
Select an account.
2. Scroll down and select Manage Transactions.
3. Select Clear trans. log. The Clear the transaction log? screen is
displayed.
NOTE:
i
is, transactions that have not been uploaded to the Data
Center), you are given a choice to upload or clear the log
(delete the transactions). You need to choose one before
continuing.
4. Select Yes, clear to clear the log. The system returns to the
Transactions menu screen.

Setting When Transaction Log Full Message Displays

You can set a warning to notify you when the transaction log is full
when it reaches a certain percentage. The default setting is 80%,
which means that when the transaction log is 80% full, you will
receive a warning. The lowest setting you can use is 80%. The
highest setting you can use is 100%.
Follow the steps below to set the percentage of how full the log is
before the system notifies you of a "Log Full" message.
1. Press the Home key to display the Home screen, then select
Select an account.
2. Scroll down and select Manage Transactions.
3. Press the green down arrow key twice and select Log full
warning.
4. Enter a value between 80 and 100 (representing the percentage
full) and select OK.
5. The system returns to the Transactions menu screen.
SV62371 Rev. A
If there are transactions in the log at this point (that
5 • Transaction Options
5-9