MOTO GUZZI stelvio 1200 NTX MY11 Service Manual page 293

Stelvio 1200 NTX MY11
Turn the support (5) over.
Assemble the ball joint (4) with the buffer and a
rubber hammer.
Fit the stop ring (3) in the support (5) with suitable
pliers.
Manually assemble the new sealing rings (2) and
(7).
Assemble the bushing (1).
Drive the bushing (1) in with a plastic hammer.
Turn the support (5) over and assemble the other
bushing (8).
Possible Cause
1. Fitting error of the radial seal or seal damaged 2. Sliding
surface of the wheel axle seal spoiled or damaged
Revente Interdite - Revendita Vietata - Resaling Forbiden - Wiederverkauf Verboten
TROUBLESHOOTING
1. Replace the sealing ring and fit it correctly with the suitable
tool
Operation
2. Replace the wheel axle
CHAS - 293
Chassis