MOTO GUZZI stelvio 1200 NTX MY11 Service Manual page 209

Stelvio 1200 NTX MY11
•
Fix the head with the two screws.
•
Tighten nuts and screws to the prescri-
bed torque operating diagonally and in
stages.
•
Loosen the valve set screws.
•
Using a thin screwdriver relief oil pres-
sure from the left cylinder chain ten-
sioner.
•
Screw two screws in the threaded
holes of the timing system upper gear.
•
Rotate the camshaft so that its pin is
aimed towards the hole in the timing
system chain.
•
Place the gear in the chain.
•
On the left camshaft pin, fit the hole
marked with the letter "L" of the timing
system gear.
•
Block the left chain tensioner hole with
screw and washer.
•
Rotate the crankshaft by 90°so that the
right cylinder piston reaches the TDC;
lock crankshaft rotation.
•
Also determine the thickness of the
gasket for the right cylinder, to be fitted
between the head and the cylinder as
described in the section: Shimming
system.
•
Place the two dowel pins.
Revente Interdite - Revendita Vietata - Resaling Forbiden - Wiederverkauf Verboten
Engine
ENG - 209