Resetting The System - Raritan MCCAT18 User Manual

Function Key Description
F4 Displays the Configuration Menu.
F5 Displays the Administration Menu.
F6 Turns on the AutoScan function.
Alt+F6 Turns off the AutoScan function.
F7 Turns on the AutoSkip function.
Alt+F7 Turns off the AutoSkip function.
F8 Checks channels one by one and updates the channel status accordingly.
F12 Toggles the channel sorting between sorting by "channel number" and
sorting by "name" in the Selection Menu.
Esc Quits the current menu or the OSD interface.

Resetting the System

To restore all MCCAT settings back to factory defaults, follow the
procedure below. Note that this function should be performed on the
first‐tier MCCAT unit alone f yours is a two‐tier system.
1. Power OFF the MCCAT unit.
2. Press the channel number 3 button on the front panel, and then
3. Continue to hold down the channel number 3 button until you hear
Chapter 4: Advanced Operation and System Configuration
power ON the MCCAT unit.
the beep sound.
Warning!! If you perform the reset function on a two‐tier system, all of
the second‐tier units will be programmed back as the first‐tier units.
Therefore, you need to programme them as the second‐tier devices
once again. For instructions on programming an MCCAT unit as a
second‐tier device, see STEP 1: Programme an MCCAT Unit as a
Second‐Tier Device (on page 33).
31