MAINTENANCE PROCEDURES
This section includes instructions for
basic maintenance procedures. If you
have the necessary mechanical skills
and the required tools, you can per-
form these procedures. If not, see
your authorized Can-Am dealer.
Other important items in the mainte-
nance schedule that are more difficult
and require special tools are best per-
formed by your authorized Can-Am
dealer.
NOTE: Maintenance message can
be removed by alternately pressing
the override switch and brake pedal
3 times at power up.
WARNING
Unless otherwise indicated, al-
ways turn ignition switch to the
OFF position before performing
any maintenance and remove key.
WARNING
Should removal of a locking de-
vice be required (e.g. lock tab,
self-locking fastener, etc.) , always
replace it with a new one.
Engine Air Filter
NOTICE
Never modify the air in-
take system. Otherwise, engine per-
formance degradation or damage
can occur. The engine is calibrated
to operate specifically with these
components.
NOTE: When riding in dusty or muddy
conditions, it is recommended to add
engine air post-filter, supplied with the
vehicle, under the main engine air filter
in second section (clean chamber) of
engine air filter housing.
Engine Air Filter Replacement
Guideline
Engine Air filter replacement fre-
quency should be adjusted according
to riding conditions as it is critical to en-
sure proper engine performance and
life span.
Engine Air filter replacement fre-
quency must be increased for the fol-
lowing severe riding conditions:
– Riding on dry sand.
– Riding on dry dirt covered surfaces.
– Riding on dry gravel trails or similar
conditions.
– Riding in areas with high concentra-
tion of seeds or crop husks.
– Riding in severe snow conditions.
NOTE: Riding in a group under these
conditions would increase even more
the air filter replacement frequency.
Engine Air Filter Removal
1. Unlatch the service cover as fol-
lows.
NOTICE
scribed procedure for opening the
service cover may lead to cover
damage.
tbl2013-009-040_a
Step 1: Push down service cover and HOLD
Step 2: Lift the front part of service cover
_______________
Failure to follow the de-
75