Maintenance Procedures; Accessing Maintenance Components - Can-Am MAVERICK Trail 2021 Series Operator's Manual

MAINTENANCE PROCEDURES

This section includes instructions for
basic maintenance procedures.
Due to the complexity of some of the
maintenance procedures, good me-
chanical skills are required. If you are
not comfortable with these proce-
dures, do not hesitate to contact an
authorized Can-Am off-road dealer, re-
pair shop or person of your own choos-
ing.
WARNING
Unless otherwise indicated, al-
ways turn ignition switch to the
OFF position before performing
any maintenance and remove key.
WARNING
Should removal of a locking de-
vice be required (e.g. lock tab,
self-locking fastener, etc.) , always
replace it with a new one.
Accessing Maintenance
Components
Front Service Cover
To open the front service cover, pull up
on handle toward the front.
219001880-111_a
1. Handle
It is very important to follow the steps
shown to close the front service cover.
1. Locate the trim clips under the ser-
vice cover.
______________
104
219001880-107_a
2. Align the BRP logo with the locating
dowel.
219001880-110_a
1. BRP logo
2. Locating dowel pin
219001880-108_a
1. Locating slot on underside of service cover
3. Slide the front edge of the service
cover under the front fascia.
4. Push down cover making sure all
the tabs are fully seated.
Seats
To remove the seats to access the rear
service cover, remove the seats as fol-
low.