Gearbox Oil - Can-Am Maverick Operator's Manual

tmo2013-003-021_a
1. Mufflers
2. Cleanout plugs
Block the end of the mufflers with a
shop rag and start engine.
Momentarily increase engine RPM
several times to purge accumulated
carbon out of the mufflers.
Stop engine and allow mufflers to cool.
Reinstall the cleanout plugs.

Gearbox Oil

Gearbox Oil Level Verification
Place the vehicle on a level surface.
Select PARK position.
Check the gearbox oil level by remov-
ing the gearbox oil level plug.
tmo2011-001-117_a
1. Engine oil dipstick
2. Gearbox oil level plug
The oil should be level with the bottom
of the oil level hole.
NOTICE
with an improper oil level may se-
verely damage gearbox.
Recommended Gearbox Oil
Use the following gearbox oil.
RECOMMENDED GEARBOX OIL
XPS synthetic gear oil (P/N 293 600 140)
NOTE: The XPS oil is specially formu-
lated to meet the lubrication require-
ments of this gearbox. BRP strongly
recommends the use of its XPS oil.
However, if the XPS synthetic gear oil
is not available, use the following lubri-
cant:
GEARBOX OIL REQUIREMENT
75W 140 API GL-5 synthetic gear oil
NOTICE
of oil when servicing.
Gearbox Oil Change
NOTE: When replacing the gearbox
oil, it is recommended to clean the ve-
hicle speed sensor (VSS) at the same
time.
Place the vehicle on a level surface.
Clean drain plug area.
Clean the oil level plug area.
Under the vehicle, place a drain pan un-
derneath the oil drain plug area.
Remove the oil level plug.
Remove the gearbox drain plug.
_______________
MAINTENANCE PROCEDURES
Operating the gearbox
Do not use another type
91