Can-Am Maverick Operator's Manual page 96

MAINTENANCE PROCEDURES
tmo2013-004-011_a
1. Central skid plate
2. Access holes
NOTE: Use wrench supplied in tool kit
to remove screws.
tmo2013-003-048_a
1. Lower screws
NOTE: Remove the center top screw
last to support the cover during re-
moval.
NOTE: Do not use and impact tool to
remove CVT cover screws.
Remove the CVT cover and its gasket.
______________
94
tmo2013-003-062_a
1. CVT cover lower screws
2. CVT cover screws
3. CVT cover
4. Gasket
Check inside front and rear CVT outlet
hoses to make sure there are no de-
bris.
tmo2013-003-059_a
TYPICAL
1. Inside CVT outlet hose
CVT Cover Installation
Install the center top screw of first.
Tighten the CVT cover screws as per
following sequence.