Can-Am Maverick Operator's Manual page 91

tmo2011-001-501_a
1. Front cylinder bleed screw
tmo2011-001-502_a
1. Rear cylinder bleed screw
2. Remove the pressure cap.
3. Fill the cooling system until coolant
comes out of the bleed screw(s).
4. Install the bleed screw(s) using
NEW gasket ring(s) and torque as
per following chart.
BLEED SCREW INSTALLATION
GASKET
RING
New
5. Continue adding coolant until sys-
tem is full up to the pressure cap
seat in the refill adapter.
TORQUE
4.4 N•m to 5.6 N•m
(39 lbf•in to 50 lbf•in)
tmr2011-011-028_a
1. Cooling system refill adapter
2. Expansion tank hose
3. Coolant system full level (pressure cap seat)
6. Install pressure cap.
NOTICE
be carried out as specified to ensure
proper cooling system bleeding in
addition to the previous steps.
7. Lift the entire front end of the ve-
hicle so the front tires are 65 cm
(26 in) above the ground for at least
1 minute.
tmo2013-003-038_a
ENTIRE FRONT END LIFTED
1. Ground level
A. 65 cm (26 in)
8. Lower vehicle to the ground.
9. Remove pressure cap and add
coolant as required.
10. Install pressure cap.
11. Lift driver's side of vehicle 65 cm
(26 in) above it's horizontal posi-
tion for at least 1 minute.
_______________
MAINTENANCE PROCEDURES
The following steps must
89