Spark Plugs - Can-Am Maverick Operator's Manual

MAINTENANCE PROCEDURES
tmo2011-001-097_a
1. Oil drain plug
2. Skid plate opening
Let oil completely drain from gearbox.
Install the drain plug.
NOTE: Clean drain plug from any
metallic particles prior to installation.
Refill gearbox.
NOTICE
Use ONLY the recom-
mended type of oil.
The oil should be level with the bottom
of the oil level orifice.
NOTICE
Do not overfill.
Reinstall oil level plug.
Wipe off any spillage.

Spark Plugs

Access to Spark Plugs
1. Remove both seats.
2. Remove upper console retaining
screws and plastic rivets.
3. Slightly lift upper console to allow
removal of lower console.
4. Remove lower console plastic riv-
ets.
5. Pull lower console out of location.
Spark Plug Removal
Unplug spark plug cable.
NOTE: Spark plug removal procedure
is the same for both cylinders.
Clean spark plug and cylinder head
with pressurized air.
______________
92
CAUTION Always wear safety
goggles when using pressurized air.
Unscrew spark plug completely then
remove it.
tmo2011-001-110_a
RH SIDE — REAR CYLINDER
1. Spark plug
tmo2011-001-111_a
LH SIDE — FRONT CYLINDER
1. Spark plug
Spark Plug Installation
Prior to installation make sure that con-
tact surface of cylinder head and spark
plug is free of grime.
Using a feeler gauge, set the spark plug
gap.