Brakes; Seat Belts - Can-Am Maverick Operator's Manual

Brakes

Brake Fluid Reservoir Level
Verification
With vehicle on a level surface, check
brake fluid in reservoir for proper level.
Brake fluid level should be between
MIN.and MAX. marks.
NOTE: Left front inner fender must
be removed to access the brake fluid
reservoir.
tmo2011-001-083_a
TYPICAL
1. MIN
2. MAX
NOTE: A low level may indicate leaks
or worn brake pads.
Adding Brake Fluid
Clean filler cap before removing.
Add fluid as required. Do not overfill.
NOTE: Ensure filler cap diaphragm is
pushed inside before to close the cap
on brake fluid reservoir.
Recommended Brake Fluid
Always use brake fluid meeting the
specification DOT 4 only.
WARNING
To avoid serious damage to the
braking system, do not use fluids
other than the recommended one,
nor mix different fluids for topping
up.
Brake Inspection
The brake inspection, maintenance
and repair should be performed by an
authorized Can-Am dealer.
However, verify the following between
visits to your dealer:
– Brake fluid level
– Brake system for fluid leaks
– Brake cleanliness.
The brake fluid replacement or
brake system maintenance and
repairs should be performed by an
authorized Can-Am dealer.

Seat Belts

Seat Belt Cleaning
To clean dirt and debris from the seat
belts, sponge the straps with mild soap
and water. Do not use bleach, dye, or
household detergents.
Do not use pressure washer to
clean seat belt components. Use
of pressure washer can perma-
nently damage seat belt compo-
nents.
______________
MAINTENANCE PROCEDURES
WARNING
WARNING
105