Suspensions - Can-Am Maverick Operator's Manual

MAINTENANCE PROCEDURES
TIGHTENING TORQUE
Beadlock
screws (FINAL
TORQUE)
tbl2011-001-068_a
TYPICAL - FINAL TIGHTENING SEQUENCE
9. Inflate tire to seat the inner bead on
wheel. Always use safe practices,
such as a tire safety cage.
WARNING
Never exceed tire's recommended
maximum pressure for seating
beads.

Suspensions

Front and Rear Suspension
Lubrication
Use SUSPENSION GREASE (P/N 293
550 033) or an equivalent.
Lubricate front and rear A-arms.
There are four grease fittings on each
front A-arm oriented downwards.
______________
104
8 N•m ± 1 N•m
(71 lbf•in ± 9 lbf•in)
tbl2013-009-022_c
FRONT SUSPENSION - TYPICAL
1. Grease fittings
There are six grease fittings on each
rear suspension side.
tmo2013-003-036_a
REAR SUSPENSION - TYPICAL
1. Grease fittings
Suspension Inspection
See an authorized Can-Am dealer if any
problem is detected.
Shock Absorbers
Inspect shock absorber for leaks,
bump stop wear out or other damages.
Verify fasteners are still well tightened.
Front A-Arms
Check A-arms for cracks, bending or
other damages.
Rear A-Arms
Check A-arms for cracks, bending or
other damages.