Table of Contents
Advertisement
MAINTENANCE PROCEDURES
NOTICE
To avoid any damage to
front brake discs, never remove or
ride vehicle without front discs pro-
tectors properly installed.
vmo2008-011-103
DISC PROTECTOR
Wheel Installation
At front, ensure that brake discs pro-
tectors are properly installed.
vmo2008-011-104_a
FRONT WHEEL
1. Disc protector
Install nuts and washers (where appli-
cable).
WARNING
On X xc models, install the tapered
side on the nuts towards rim.
______________
104
Gently tighten nuts in a criss-cross
sequence then apply a final torque of
52 N•m (38 lbf•ft).
NOTICE
Always use the recom-
mended wheel nuts and washers (if
applicable). Using a different nut
and washer could cause damages to
the rim.
Front Wheel Bearings
Front Wheel Bearings Inspection
Push and pull the wheels from the up-
per edge to feel the play. See an autho-
rized Can-Am dealer if there is any play.
Rear Axle
Rear Axle Inspection
Lift rear of vehicle high enough to have
wheels off the ground.
Push and pull rear axle to feel the play.
Look for axle bending or runout.
See an authorized Can-Am dealer if
there is any play or damage.
Suspensions
Suspensions Inspection
Shock Absorbers
Inspect shock absorber for oil leaks and
fasteners for tightness. See an autho-
rized Can-Am dealer if necessary.
WARNING
– Shock absorbers are pressur-
ized.
– An explosion may occur if heat-
ed or punctured.
– Do not disassemble.
Hide quick links:
Advertisement
Table of Contents
