Card Test Diagnostics - Allied Telesis AT-2400T Installation Manual

Card Test
To run a card test diagnostics, perform the following procedure:
Diagnostics
1.
2.
3.
4.
Configuration - Specifies connection options, for example, speed
and duplex mode of the card or to enable or disable Boot ROM.
Diagnostics - The Card Test verifies that your computer and the
adapter card can communicate. To run a Card Test, refer to
Diagnostics on page 115.
View Information File - Refers you to the documentation on the
CardAssistant CD.
From the Main Menu, select Diagnostics.
The screen shown in Figure 97 is displayed.
Figure 97 Diagnostics Menu
Select Card test.
Press <Enter>.
A screen is displayed, showing the Card Tests results for the
following:
EEPROM - checks that the EEPROM was read and certain values are
valid.
Loopback - checks whether a packet can be sent from memory to
the adapter card and back to memory successfully.
Line - checks for a valid connection between the adapter card and
the remote Ethernet hub or switch.
Network Adapter Card Installation Guide
Card Test
115