Installing The Switch; Installing The Horizontal Stabilizer - Seagull Models Piper Cub Assembly Manual

PIPER CUB _
CODE SEA 87

INSTALLING THE SWITCH.

Install the switch into the precut hole in the
side of fuselage.
Switch.
INSTALLING THE FUSELAGE SERVO.
Because the size of servos differ, you
may need to adjust the size of the precut open-
ing in the mount. The notch in the sides of the
mount allow the servo lead to pass through.
1) Install the rubber grommets and brass
collets onto the throttle servo. Test fit the servo
into the aileron servo mount.
2) Secure the servos with the screws pro-
vided with your radio system.
Elevator servo.
Elevator servo.
THROTTLE SERVO ARM INSTALLATION.
Install adjustable servo connector in the servo
arm .
12
.
Throttle servo.
Rudder servo.
Instruction Manual
Loctite secure.
1 pcs.
Elevator servo .
Elevator servo .
INSTALLING THE HORIZONTAL
STABILIZER.
Draw center line.
When cutting through the covering to re-
move it, cut with only enough pressure
to only cut through the covering itself. Cutting
into the balsa structure may weaken it.
Adjustable Servo
connector.
Servo arm.
Throttle servo arm.
Rudder servo .
pen.