Configuration On The Machine - Xerox apeosport 550 I Network Administration Manual

Configuration on the Machine

The following describes the configuration procedure to connect the machine to a
NetWare network.
Note
For information on how to use CentreWare Internet Services, refer to "Using CentreWare Internet
Services" (P.55).
Using IPX/SPX
1
Display the [System Administrator Menu] screen.
1) Press the <Log In/Out> button.
2) Enter the user ID with the numeric keypad or a keyboard displayed by pressing
[Keyboard], and select [Confirm].
Note
3) Select [System Settings].
2
Enable the NetWare port.
1) Select [System Settings].
2) Select [Network Settings].
3) Select [Port Settings].
4) Select [NetWare], and select [Change Settings].
5) Select [Port Status], and select [Change Settings].
6) Select [Enabled], then select [Save].
3
Select [Close] repeatedly until the [System Settings] screen is displayed.
4
Select [Exit].
5
After the machine is restarted, print out a settings list to confirm that the NetWare port
is enabled, the NetWare device name and the network address.
For information on how to print a settings list, refer to "Print Report/List" under "Chapter 13 Machine
Status" in the User Guide.
6
Configure the machine using the CentreWare Utilities CD-ROM.
Refer to the manual contained in the CentreWare Utilities CD-ROM for the configuration procedure.
Using a LPD Port in NDPS
1
Display the [System Administrator Menu] screen.
1) Press the <Log In/Out> button.
2) Enter the user ID with the numeric keypad or a keyboard displayed by pressing
[Keyboard], and select [Confirm].
Note
3) Select [System Settings].
2
Enable the LPD port.
1) Select [System Settings].
2) Select [Network Settings].
• The configuration can also be performed using CentreWare Internet Services or
CentreWare Utilities.
• The default user ID is "11111". When using the Authentication feature, a password is
required. The default password is "x-admin".
• The default user ID is "11111". When using the Authentication feature, a password is
required. The default password is "x-admin".
Installation Procedure
51
6