9 Installation When Using EtherTalk
Preparations
Prepare the following items to install the machine when using EtherTalk interface.
Installation Procedure
Installation Overview
The machine can be connected to computers using an EtherTalk network.
The following is the procedure to use EtherTalk.
Configuration on the Machine
The following describes the configuration procedure to connect the machine to an
EtherTalk network.
Enable the EtherTalk port
Note
For information on how to use CentreWare Internet Services, refer to "Using CentreWare Internet
Services" (P.65).
1
Display the [System Administrator Menu] screen.
1) Press the <Log In/Out> button.
2) Enter the user ID with the numeric keypad or a keyboard displayed by pressing
9
Note
3) Select [System Settings].
2
Enable the EtherTalk port.
1) Select [System Settings].
2) Select [Network Settings].
3) Select [Port Settings].
4) Select [EtherTalk], and select [Change Settings].
5) Select [Port Status], and select [Change Settings].
6) Select [Enabled], then select [Save].
3
Select [Close] repeatedly until the [System Settings] screen is displayed.
4
Select [Exit].
62
EtherTalk network environment
PostScript 3 Kit (optional)
Configuration on the Machine
Setting EtherTalk on the machine.
Configuration on the computer
Installing a print driver.
• EtherTalk can be configured when a PostScript 3 Kit (optional) is installed.
• The configuration can also be performed using CentreWare Internet Services.
[Keyboard], and select [Confirm].
• The default user ID is "11111". When using the Authentication feature, a password is
required. The default password is "x-admin".