Electrical Connection; Installing The Power Supply Cable; Water Connection - Sanremo ROMA TCS SED Instruction Booklet

ENGLISH
Before connecting the power cable, follow the instructions below to install a safety switch and of the proper capacity:
Install ground cable, then phase cables. Uninstall phase cables first and then ground if needed.
Make sure the ground connection complies with existing standards and regulations.
N.B. CHECK THAT THE DATA ON THE RATING PLATE CORRESPOND TO YOUR MAINS ELECTRICITY SUPPLY.

INSTALLING THE POWER SUPPLY CABLE

1) Only cold water must be supplied to the appliances.
2) If the mains water pressure exceeds 6 bar, a pressure reducer must be installed to regulate the outlet pressure to a maximum of 6 bar.
3) Connect the drain hose to the tray, avoiding sharp bends and keeping a sufficient slope for regular flow of the drain water.
4) Connect the 3/8" hose to the mains outlet and then to the water softener and to the appliance.
N.B. A water softener is indispensable for correct appliance operation, best coffee in the cup and long life of the components, since it removes scale
and residues from the water that would otherwise shorten their life.
The company is relieved of all and any liability in the event of failure to comply with the above instructions.
Open the tap and let water flow through the deconcentrator to clear dirt off the circuit before plugging the hose into the pump.

ELECTRICAL CONNECTION

WATER CONNECTION

46