Electrical Connection; Installing The Power Supply Cable; Water Connection - Sanremo TORINO SAP Instruction Booklet

ENGLISH
Before connecting the power cable, follow the instructions below to install a safety switch and of the proper capacity:
Install ground cable, then phase cables. Uninstall phase cables first and then ground if needed.
Make sure the ground connection complies with existing standards and regulations.
To connect directly to the mains electricity supply, include a device to disconnect the appliance from the mains, with a contacts opening distance
which allows complete disconnection in conditions of category III overtension, in compliance with the installation rules.
N.B. CHECK THAT THE DATA ON THE RATING PLATE CORRESPOND TO YOUR MAINS ELECTRICITY SUPPLY.
When installed, the boiler and heat exchangers are dry to avoid possible damage to the appliance caused by freezing.
1) The appliance must be supplied with cold water only.
2) If the mains pressure is higher than 0.6 Mpa (6 bars), you must install a pressure regulator with 0.6 Mpa (6 bars) maximum output pressure.
3) Connect the drain hose to the drip tray, avoiding excessively tight curves and sloping the hose appropriately to facilitate water flow.

ELECTRICAL CONNECTION

INSTALLING THE POWER SUPPLY CABLE

WATER CONNECTION

26