Programming The Clock - Sanremo ROMA TCS SED Instruction Booklet

page of 155

/ 155
Contents
Table of Contents
Bookmarks

Table of Contents

Available languages

ENGLISH

During programming, only the LED corresponding to the continuous/3coffee button being programmed remains lit.

PROGRAMMING TEA DOSES

It is possible to modify and memorise the quantities for tea doses (with timed control) following the procedure described below:

1) In IDLE-ON status press the button K5GRx (1..3) and hold it down for longer than 5 seconds; check that the led L5GRx (1..3) changes from

fixed to flashing.

the display shows:

2) Within 10 seconds (time-out for leaving the programming phase) press the button K6GRx associated with the tea dose. The led for the button

K5GRx remains lit.

The actuator EVTEA is enabled for the whole duration of programming the tea dose.

3) When the tea quantity at which you want to programme the dose is reached, press again the button K6GRx used previously to interrupt the

distribution of the product with consequent de-energising of EVTEA.

The new time for the duration of the tea dose is memorised.

•

To programme the remaining tea doses (if the programming time-out of 30 seconds has not been exceeded and you have not entered programming

from group 1 by pressing the button K5GR1), repeat points (2) and (3) in sequence.

•

If the programming time-out (30 seconds) has intervened, to proceed with programming you must repeat the entire sequence described in points

(1), (2) and (3).

•

The leds for the doses "already programmed" are off if you decide to return to programming. However this does not prevent a "new" programming

of the doses already programmed (this condition cannot occur if a dosing ON/OFF operation has been performed after programming).

IMPORTANT: the programming of the tea dose carried out on the FIRST GROUP is NEVER automatically transferred to all the other groups too.

To programme the tea dose on the remaining groups it is sufficient to repeat the operations described in points (1), (2) and (3).

NOTE: during programming of one tea, the groups and the distribution of other teas remain disabled.

PROGRAMMING STEAM TEMPERATURE BY SIMULATION

It is possible to modify and memorise the temperature at which the EVVAP must be deactivated. The temperature may be programmed by

simulation, following the procedure described below.

1) In IDLE-ON status press the button K5GRx (1..3) and hold it down for longer than 5 seconds; check that the led L5GRx (1..3) changes from

fixed to flashing.

the display shows:

2) Within 30 seconds (time-out for leaving the programming phase) press the button K6GRx associated with steam. The led for the button K5GRx

remains lit.

The actuator EVVAP is enabled for the whole duration of programming.

3) When the desired temperature is reached (measured with an external probe or in another way chosen by GICAR), press again the button K6GRx

used previously to interrupt the distribution of the product with consequent de-energising of EVTEA.

The new steam temperature value (steam spout) is memorised.

•

If the programming time-out (30 seconds) has intervened, to proceed with programming you must repeat the entire sequence

described in points (1), (2) and (3).

NOTE: during Steam programming the other groups are disabled.