Switching Off; Coffee Cycle - Sanremo ROMA TCS SED Instruction Booklet

ENGLISH
the display shows:

SWITCHING OFF

To switch off the doser, hold down first the key K5GR1 and then immediately the key K3GR1.

COFFEE CYCLE

DISTRIBUTION
From idle-on state, the six LEDs L1-L6 in the three groups are in the ON state.
Pressing one of the four dose buttons belonging to the group from which you want
to distribute the dose (for example K1GRx) , both the distributing solenoid valve EVx
and the PUMP will be energised, launching the distributing phase. The pump and
the solenoid valve will remain activated until the previously programmed quantity of
product (flow meter impulses) is reached. The LED corresponding to the button of
the chosen dose remains lit throughout coffee distribution, while the others are in
the OFF state.
the display shows:
During distribution the display indicates the dose given (English version)
1 Espresso
2 Espresos
1 Coffee
2 Coffees
Continuos
Tea
Steam
NOTE: If keypad 6T/12L is used, as well as normal management
of the LED corresponding to the dose requested (see above), the 6
LEDs on the keypad (L7GRX - L12GRX) will switch on sequentially
to indicate the duration of the dose being distributed. From the
moment the request for distribution is given and the distribution
solenoid valve EVx and PUMP are energised, LEDs L7GRX, L8GRX,
L9GRX, L10GRX, L11GRX and L12GRX will switch on in sequence.
At the same time as L12GRX comes on, the dose is distributed, the
system de-energises the solenoid valve EVx and the PUMP and the
LED corresponding to the dose concerned goes off. At the end of
distribution of a dose, LEDs L7GRX - L12GRX will remain ON (unless there is a further request for distribution in the meantime) for about 10", after
which they will all switch OFF.
STOP COFFEE DISTRIBUTION IN PROGRESS
It is possible to interrupt the distribution in progress before reaching the programmed
impulses on the flow meter by pressing any one of the dose buttons on the keyboard
of the group used for distributing the product.
This operation immediately de-energizes both the distribution solenoid valve EVx and
the PUMP , interrupting the distribution of the product and returning the doser to idle-on
status. All LEDs on the keypad are in the ON state.
NOTE: As well as normal management of STOP DISTRIBUTION (see above), the 6T/12L
IN IDLE-ON STATUS ALL THE LEDS ARE LIT
xxx°C hh:mm
SANREMO
DISTRIBUTION
Brewing
Espresso
53
where hh = present hour (0 ÷ 23)
mm = present minute
GICAR srl = customer name desired
Gr:x
START DISTRIBUTION
STOP DISTRIBUTION