Installation; Electrical Connection - Sanremo MILANO S Instruction Booklet

ENGLISH
MILANO S
The weighted sound pressure level A of the coffee machine is less
than 70dB.
For correct appliance operation and trouble-free maintenance, please read this
booklet carefully and comply with the instructions and rules, also referring to the
diagrams given in it.
WARNINGS
The appliance must not be cleaned using a water jet. Do not put the
appliance in water.
The appliance must not be positioned near to any source of heat. The
appliance is unsuitable for outdoor installation.
To ensure safe use the appliance must be in a level position.
If the power cable is damaged, have it replaced by a SANREMO
After-Sales Service Centre, since a special tool is required for this
purpose.
The appliance must be used in rooms with a temperature between
5°C and 35°C.
The machine is supplied with the hydraulic circuit empty. If for any
reason the machine is frozen after first installation, make sure to
unfreeze it before turning on. Take the machine to an adequate
ambient temperature, connect a drain hose to the tray coupling, open
the drain tap, wait for complete discharge of the water, disconnect
the hose and close the drain tap, then follow the normal installation
procedure.
IN THE EVENT OF FAILURE OR MALFUNCTION, REQUEST SERVICE
ONLY FROM QUALIFIED PERSONNEL AT THE AFTER-SALES SERVICE
CENTRE
The data and features indicated in this booklet are not binding on the
manufacturer, which reserves the right to make changes to its models at any
time.
The manufacturer shall not be under any liability for injury to persons or damage
to property arising from failure to comply with the instructions given in this booklet

INSTALLATION

Before installing the appliance ensure that the mains voltage and power
correspond to the data given in the specifications table. Take the appliance out
of the packaging and put it in its final place of installation ensuring that it is stable
and safe and that there is the necessary space for using it. Place the machine in
a way that the distance between the grid and the floor is wider than 1,5 mt.

Electrical connection

Before connecting the power cable, follow the instructions below to install a safety
switch and of the proper capacity:
Install ground cable, then phase cables. Uninstall phase cables first and then
ground if needed. Make sure the ground connection complies with existing
standards and regulations.
N.B. CHECK THAT THE DATA ON THE RATING PLATE CORRESPOND TO YOUR
MAINS ELECTRICITY SUPPLY.
19