Advertisement
Quick Links
Sanremo Café Racer Installation & Quick Start Guide
Disclaimer: Installation must be performed by professional technician. Improper installation can void warranty, permanently damage equipment and/or present burn
& electrical hazard to installer/user. Consult with local municipality for official electrical and plumbing codes/guidelines.
Consult user manual for expanded installation, operation, and safety guidelines.
Dimensions
3 Group
2 Group
Water Requirements
Electrical Requirements
2 Group
3 Group
Receptacle & Plug Configuration
Advertisement
Related Manuals for Sanremo CAFE RACER
Summary of Contents for Sanremo CAFE RACER
- Page 1 Sanremo Café Racer Installation & Quick Start Guide Disclaimer: Installation must be performed by professional technician. Improper installation can void warranty, permanently damage equipment and/or present burn & electrical hazard to installer/user. Consult with local municipality for official electrical and plumbing codes/guidelines.
- Page 2 Connection & Counter Hole Diagrams 3” hole in counter recommended for passage of electrical cord & water/drain lines. Counter hole placement recommended to be center of machine and 17” inward from edge of the drip tray. First Start Procedure Confirm the steam boiler has auto filled sufficiently and has not timed out by referencing the center water level display section of the pressure gauge: Steam Boiler Water Level Low Steam Boiler Water Level Filling...
- Page 3 Air Purge Procedure Press and hold the air purge button for 10 seconds or until air can no longer be heard purging the circuit Once the machine has reached operating temperature, perform second purge & group purge • Repeat general circuit purge procedure (Press and hold purge button without any groups running) •...
- Page 4 Adjusting water mix for hot water (tea) tap (Continue to next page for group programming)
- Page 5 To program / adjust each group, press and hold continuous button and press hot water tap button Short dose button= decrease value | Continuous button = move to next parameter | Long dose button = increase value Group Temperature Cup Tray Warmer Cup Tray Warmer Temp Group Pre-infusion Long Dose Pre-infusion...
- Page 6 Individual Group Cleaning Mode PRESS HOLD For complete (all group) cleaning mode, please refer to user manual...
-
Page 7: Warranty Terms And Conditions
SANREMO TSD (Technical Service Iron: 0 ppm Department) will be replaced. SANREMO Srl has the right to make changes to its products at any Water levels outside of these parameters can void warranty. Consult with a water filtration professional for water testing time necessary for technical and / or aesthetic reasons, reserving and recommended systems.