Step 2. Secure the PCI backplane by screwing in its mounting screws.
Figure 6-59 Replacing the PCI Backplane
Step 3. Replace any PCI and graphics cards. (See "Replacing a PCI or Graphics Card" on page 204.)
Step 4. Replace the PCI card cage. (See "Replacing the PCI Card Cage" on page 202.)
Step 5. Verify the backplane replacement and operation by using the system utilities. (See the Utilities
chapter or the HP Integrity and HP 9000 iLO MP Operations Guide for additional information.)
•
Use the iLO MP commands to verify operation.
•
Use the BCH commands to verify operation.
Removing and Replacing a Removable Media Drive
The removable media drive is located behind the front bezel.
Ensure that the server is powered off and all power sources have been disconnected
WARNING
from the server before removing or replacing a removable media drive.
Voltages are present at various locations within the server whenever an ac power
source is connected. This voltage is present even when the main power switch is in
the off position.
Failure to observe this warning can result in personal injury or damage to
equipment.
Chapter 6
Removing and Replacing Components
Removing and Replacing a Removable Media Drive
207