Transporting The Printer - MUTOH ValueJet VJ-1204 User Manual

3.8.2 Transporting the printer

When transporting the printer, it is necessary to pack the printer as it was shipped, using the protective
materials and packing materials to protect the printer from vibration and shocks.
Notes
•
When transporting the printer, consult your MUTOH product dealer.
(1) Pre- transport procedure
Step 1 : Switch ON the printer.
Step 2 : Verify that the printer is in Normal mode.
Step 3 : Remove all ink cassettes.
Step 4 : Switch OFF the printer.
• Result: The operation panel displays "Transport Mode", and the printer starts the ink rejecting
operation.
• The ink rejecting operation takes about 2 minutes.
Step 5 : Verify that the power light faints when the ink rejection operations has been finished.
Step 6 : Remove the scroller.
Step 7 : Remove all cables.
Step 8 : Attach the protective material (metal plate) for attaching the head unit (1), and fix it with
thumbscrews (2).
No.
1
2
Step 9 : Remove the printer from the stand. See Installation guide
Step 10 : Repack the printer.
(2) Post-transport procedure
Step 1 : Perform unpacking, assembling, and placing the printer. See Installation guide
Step 2 : Set the printer in an available condition. See "Transferring the printer" and "Steps after
transfer"
Protective material (metal plate) for attaching the head unit
Thumbscrew
Name
42 AP-75740 – Rev 1.1 – 23/01/2007
User's Guide ValueJet 1204
Chapter 3: Installing the Unit