Nozzle Check; Mode Print - MUTOH ValueJet VJ-1204 User Manual

4.5.3 Nozzle check

Used to check whether there are any head clogging, missing nozzles or misfiring nozzles.
Notes
•
If the nozzle check result indicates that the checked points are blurred or missing, clean the head.
See Head cleaning.
Perform the nozzle check once again after the head has been cleaned.
Notes
•
For the printing procedure, refer to "Performing a test print".

4.5.4 Mode Print

Used to confirm the following printing conditions:
•
Print mode
•
Pre heater set temperature
•
Fixer (Platen) heater set temperature
•
Drier heater set temperature
•
Adjustment value
Notes
•
For the printing procedure, refer to "Performing a test print".
67 AP-75740 – Rev 1.1 – 23/01/2007
User's Guide ValueJet 1204
Chapter 4: Handling the printer