Table of Contents
Advertisement
3.6. INSTALLING INK CASSETTES
The installation of ink cassettes for the first time into the unit is explained below.
Caution :
•
Caution :
Notes :
The unit is delivered / shipped with special shipping liquid. This to prevent air coming
into the ink supply system. Make sure that air never comes into the ink supply system.
To install ink cassettes, follow the steps below.
Caution :
Step 1 :
Before powering ON the unit for the first time, please be sure to have :
8 cleaning cassettes compatible with the ink
8 ink cassettes of the requested ink configuration
Step 2 :
Check if the Waste Bottle is empty.
Mutoh's DT-Series Printers – Operation Instructions
Before powering ON the unit, make sure the waste bottle is installed, the clamps of
the waste tubing are removed and the dummy cassettes are removed.
When handling ink cassettes, be careful that ink does not get in your eyes or on your
skin. However, if this happens, flush immediately with water. Otherwise, your eyes
may become congested or inflamed slightly. If you feel discomfort, consult a doctor
immediately.
Do not disassemble ink cassettes. Otherwise, ink may get in your eyes or on your
skin.
Do not shake ink cassettes strongly. Otherwise, ink may leak.
Before powering ON the unit for the first time, make sure to:
Remove the dummy cassettes
Remove the waste tube clamps
Remove the bag enclosing the waste tubes
Connect the waste tubes
50
AP-75171, Rev. 1.1, 25/06/04
Advertisement
Table of Contents
