Setting Up Nokia Ip40 Tele 8; Setting Up Check Point Ng Ai; Nokia Satellite X To Nokia Satellite X; (Vpn Gateway To Gateway) - Nokia IP40 User Manual

Setting Up Nokia IP40 Tele 8

To configure a VPN tunnel between Nokia IP40 Tele 8 and Check Point FP3, on IP40 Tele 8,
(VPN client) add a VPN site.

Setting Up Check Point NG AI

Configure a VPN-1 Edge/Embedded gateway object on the Check Point Smart Dashboard.
To set up Check Point NG AI
1. Create a gateway by using Check Point > VPN-1 Edge/Embedded gateway.
2. Create a user and add the user to the VPN users group.
3. Create a remote access VPN community.
4. In the policy editor, create a rule with the following parameters:
Source User: any
Destination: any
Through: remote access community
Target: NG AI firewall object
Note
You can also use Check Point FP3 or FP4 in place of NG AI.

Nokia Satellite X to Nokia Satellite X

(VPN Gateway to Gateway)

The VPN configuration between Nokia IP40 Satellite X and another Nokia IP40 Satellite X
enables you to establish site-to-site VPN connections between two Nokia IP40 site-to-site VPN
gateways.
Note
In this configuration, both Nokia IP40 Satellite X site-to-site VPN gateways must have a
static IP address.
Figure 8
with three Satellite X devices. Each Nokia IP40 device acts as a Site-to-Site VPN gateway for a
fully secure network. The networks communicate through VPN connections.
Nokia IP40 Security Platform User's Guide v1.1
Include NG AI firewall object in the participating gateway.
Include the Users group in the participating users.
on page 188 shows a sample implementation of the Satellite X to Satellite X solution
Nokia IP40 Tele 8 to Check Point NG AI
187