Enabling Or Disabling Ssh Service - Nokia IP40 User Manual

Note
Secure Shell access is enabled by default from the LAN and DMZ interfaces. Setting of
management rules, which is described in this section, is applicable only for allowing
SSH access from the WAN side.
3. From the SSH drop-down list, choose one of the following.
Click Internal Network to enable only computers from your internal network to access your
IP40 through SSH. Similarly, click ANY to enable any host (with any IP address) to connect
to IP40 through SSH, and so on.

Enabling or Disabling SSH Service

Note
Secure Shell (SSH) options cannot be configured from the Nokia IP40 GUI. Use the
command-line options from a command shell (such as HyperTerminal) to configure these
options. A brief list of important command-line options for configuring Secure Shell (SSH) is
included in the user guide for the purpose of introduction. For additional and detailed
information, see Nokia IP40 Security Platform CLI Reference Guide Version 1.1.
Use the following commands to enable, disable, and view the status of SSH service:
To enable the SSH service, use the following command:
set ssh server
Nokia IP40 Security Platform User's Guide v1.1
Internal Network
Internal Network + VPN
IP Address Range
ANY
enable <0 | 1>
113