Enabling Bgp Routing; Configuring The Local As And Router-Id; Configuring Nokia Ip40 Security Platform For Bgp Route Advertisement; Monitoring Bgp - Nokia IP40 User Manual

Note
You can configure BGP by using the Nokia IP40 CLI only. This feature is not supported in
the IP40 GUI. Use the command-line options from a command shell (such as Hyper
terminal) to configure these options. A brief list of important commands are included in this
guide to provide an introduction. For more information on these commands, see Nokia IP40
Security Platform CLI Reference Guide Version 1.1.

Enabling BGP Routing

Use the following command to enable the BGP routing protocol:
set bgp daemon <restart | enable | disable>

Configuring the Local AS and Router-ID

Use the following command to configure the local AS:
set bgp as <value>
Configuring Nokia IP40 Security Platform for BGP Route
Advertisement
The network and redistribute commands are used to inject routes into the BGP table. The
network-mask portion of the IP address allows supernetting and subnetting.
Use the following commands to configure route advertisements:
add bgp
Use the following commands to delete BGP route advertisement:
delete bgp

Monitoring BGP

Use the following show commands to monitor BGP activity:
show bgp config all
show bgp summary
show bgp config running
Nokia IP40 Security Platform User's Guide v1.1
router-id <value ipaddress>
network <value ipaddress | netmask-length>
redistribute <connected | kernel | static>
network <value ipaddress | netmake-length >
redistribute < connected | kernel | static >
Route Based VPN and BGP
129