Assembling The Front Constant Velocity Shaft Assemblies - Yamaha 2016 Grizzly yfm700gplg Service Manual

Table of Contents

FRONT CONSTANT VELOCITY SHAFT ASSEMBLIES, DIFFEREN-

ASSEMBLING THE FRONT CONSTANT

VELOCITY SHAFT ASSEMBLIES

The following procedure applies to both of the

front constant velocity shaft assemblies.

• Constant velocity joint "2"

• Constant velocity shaft "3"

a. Install the clip.

b. Install the constant velocity joint.

• Install the clip into the groove in the constant

velocity shaft as shown.

• Secure the constant velocity joint in a vise, and

then fit the constant velocity shaft into the con-

stant velocity joint using a hammer.

A. Wheel side

TIAL ASSEMBLY AND FRONT DRIVE SHAFT

• Ball bearing "1"

• Circlip "2"

• Double offset joint "3"

• Securely install the circlip into the groove in the

constant velocity shaft.

• Securely install the clip into the groove in the

double offset joint.

B. Differential side

• Molybdenum disulfide grease

(into the double offset joint, constant velocity

joint, and dust boots)

Molybdenum disulfide grease is included in the

• Dust boots "1"

• Boot bands "2", "3", "4", "5"

Molybdenum disulfide grease

70 g (2.5 oz) per dust boot

(wheel side)

55 g (1.9 oz) per dust boot (dif-

ferential side)

Chapters

Table of Contents